• Alteon@lemmy.world
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        What’s your print height, temperature, bed temp, and material? And what’s your magical secret to get it to adhere without issues? The max I can get down to is 0.16mm and otherwise it just becomes a wispy mess if I go any thinner. You printing PLA?

        • Ready! Player 31@lemmy.worldOPM
          link
          fedilink
          English
          arrow-up
          2
          ·
          1 year ago

          Ah no this is resin! It prints at 0.05mm.

          I used to print in FDM but switched to resin earlier this year. There’s more chemicals faff with the resin and needing ventilation etc but you can print a plate full of these models in about four hours, wash and cure, and be done with it. I was printing a single model at a time on FDM and it took like six hours.

          • Alteon@lemmy.world
            link
            fedilink
            English
            arrow-up
            2
            ·
            1 year ago

            Wow…that quality difference is fucking massive. 0.05mm is three times better than I’m able to do right now.