Hey all, I’m hoping someone who has dealt with this can help me out. I’ve got a print that would really benefit from soluble supports. I spent some time reading about using PVA picked up SainSmart PVA 500g as it was recommended on a few different places though I didn’t think to check, it doesn’t have a filament profile in Prusa Slicer, so maybe that was a mistake. I ended up picking the only other PVA filament profile in hopes it was close which I think was PrimaSelect PVA+ or something.
So I spent more time reading and people suggested print it around 190c. What I ended up doing is using the printing profile “soluble interface”, which only puts the soluble material between the support and the print. I didn’t change too many other settings (slowed down initial layer, turned off wipe tower).
What I found is that the PVA keeps triggering the filament runout sensor on the hotend, so I kept manually feeding it back in but each time it seemed to just run out again.
Additionally, the PVA would come out in big bubbles instead of thin lines. What am I doing wrong?
Re:filament sensor triggers
Are you sure it’s the PVA? I had a faulty sensor in mine and it behaved like that.
Also when it comes to soluble supports I have had excellent success using PLA and PETG. They chemically do not bond so you can print them like soluble without needing to post process it.
Yeah I’ve done a couple prints since that one with PLA and it was flawless.
That’s an interesting idea about using petg, I’ve got some so maybe I’ll give that a try. What settings did you use for them both?
If you’re doing something bigger you’ll want to set a raft - 85°C bed petg as the support, PLA as the main material.
Soluble support settings.
There’s a whole article here - https://help.prusa3d.com/article/combining-materials-xl_498103
I’m traveling at the moment so I don’t have my exact settings handy