Thank you all for your help! After yesterday’s Input I managed to Print my Box! The Problem was (mostly) the Bed temperature! The lower Bed temperature (60°C) and the now successful Firmware-Update (special thanks to DABDA) done the trick!

Thank you all for your help and your advice!

Hello I’m very new to 3D printing, I’m using a Sovol 06 with 1.75mm PLA. I’m trying to print a Box (for MTG-Cards). But everytime the bottom of the Box starts to “deatche” itself from the Bed. It starts with one corner and then progresses to the whole print. The Nozzle temperature is 200°C and the Bed temperature is 80°C. Can someone help?

  • Roflmasterbigpimp@lemmy.worldOP
    link
    fedilink
    English
    arrow-up
    2
    ·
    11 months ago

    Ive actually started another attempt with lower speed and I “loosend” the PLA from the Coil so it can be passed down more easily. If that fails I will print this test. Thank you :D